1997 Super Sport - Red/Black AIR - Work in Progress ---Lots of Photos

[surroundsound64]

Great build!!! Thanks for sharing.

[Brichter14]

Thanks Jeff! Now if the weather would cooperate i could take it out and get some use out of it!

[NautiqueJeff]

I like it! I know that graphic isn't everyone's favorite, but I have always liked it. Looks good on that boat too.

[Brichter14]

Uh oh I did what everybody told me not to do!






I think it fits with the lines of the boat better than the "super air nautique" decal would. I am really happy with the results!

[Brichter14]

Cleaner look with wire looms.

[Brichter14]

With the perko i figured gravity would help keep it dry as opposed to being on that carpeted floor.

[s_kelley2000]

Looking great, especially the new Air 210 graphics! Curious to see what you decided for the big graphic.

I like that perko placement too. I plan to to put mine in that same compartment but always figured I would mount it to the floor in there. Great to know there is enough room to mount it on that wall like you did.

[Brichter14]

Got the perko switch installed. I wanted to keep the wires from batteries short but i didnt want the switch in the engine compartment because the hatch is powered by a battery.

This storage area is never used and has a carpeted board that fits on top as well as a seat. I dont foresee any water getting to it.





Im gonna clean it all up a bit with some wire looms.

Heres the second battery. It is on the ledge in the vdrive locker, port side



I also got a replacement 12v receptacle.

[Brichter14]

Added a second battery and switch. Gonna do that tonight as well as put on the big hull decal.

Wifes pregnant so im done with upgrades for a while.

[orzech]

Very clean and subtle, i like it... so what else you got planned for since it seems like winter is never going to end

[Brichter14]

New additions.

A week or so ago i found a mirror arm on ebay for 10 bucks. It had 13 dollar shipping but for 23 bucks i got a sweet mirror arm. Brand new.





I got some goodies in the mail today. 2 sets of seadek step pads. One set on the gunnels.



Other set i cut for transom step. Not perfect but it works.





A while ago i pulled the white pinstripe separating the red and black stripes on the hull. I got some black pinstripe to make that separation now.




I also got some stainless thru hulls for the cooler drain, both bilges and the triple ballast. I also got my hull decals in and this will show the rear decals.






I will put on the big decal tomorrow. More to come!

[Brichter14]

Put my existing (kind of cheap) racks on the top cross members. I ordered a newer and alot nicer set for the sides of the tower.

[Brichter14]

Ya im gonna do this for the side decal



With this on the back








It will say Team (/) 210

[s_kelley2000]

Wow there is the perfect amount of space for that there. When I re-did my transom graphics I didn't think there was enough room for that graphic there so I didn't consider it and went with the Nautique Super Sport bubble letters across the top. Have you decided on your side graphics yet?

[Brichter14]

Got bored again so i got my heat gun out and applied my transom chromax my wife got me for xmas. Came out great!