Swapping towers

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • DWhitt
    • Apr 2006
    • 140

    • Gainesville, GA

    • 2006 SAN 220 TE Previous Boat: 2002 SAN 210 TE

    #1

    Swapping towers

    Has anyone looked into switching from a standard FCT to a Titan tower on an 07 or later 210? I need the Titan for garage clearance. There are a couple of 210's with the standard FCT that I like but I am not having much luck finding one with a titan. I may just have to be patient and order an 09. Has anyone attempted the swap? Lots of repair and re-drilling?
  • wake_fun
    1,000 Post Club Member
    • Jul 2003
    • 1330

    • CA

    • 1995 Super Sport

    #2
    I wish I could buy a new boat because my boat/tower won't fit in my garage :mrgreen:
    Photo Album
    Ballast Install 1
    Ballast Install 2
    Amp Install
    PPass Install
    Alternator Install

    Comment

    • cadestique
      • May 2008
      • 25

      • Hillsborough, NC

      • 2007 220 SANTE

      #3
      I had the swap done on a 07 220. The Titan tower has a different hole pattern and it was about 4 inches different from front to back. Yes there was glass and gel work done at all 4 mounting locations. My TE board racks would not fit back either,Titan has a different diameter and angle. It ended up a little more costly than I first thought but I think it's better than blowing my back out and dropping that heavy beast that came on it.The Titan is way easier to raise and lower than the standard FCT.

      Comment

      • rugdog65
        • Aug 2008
        • 49

        • Alabama


        #4
        does it fit in a 7 ft basement after swap?

        Comment

        Working...