Tripped breaker?

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • gdhall
    • May 2011
    • 151

    • Bainbridge, Ga

    • 2003 SANTE 210

    #1

    Tripped breaker?

    Anyone know how to access these breakers? I tried to use my outlet yesterday and it stopped working I think I tripped the breaker but now my latches won't unlock (limited) I'm guessing it's same breaker bc it's the only thing not working. 2003 210 SANTE Limited
    Attached Files
  • jpwhit
    Senior Member of PLANETNAUTIQUE
    • Aug 2016
    • 641

    • Cary, NC

    • 1998 Ski Nautique 2012 Nautique 200 2014 MasterCraft X25 . 2019 MasterCraft ProStar

    #2
    If you mean reset them, you just push in on the rubber cover over the breaker. The white button under the rubber cover pops out when they are tripped.

    Comment

    • gdhall
      • May 2011
      • 151

      • Bainbridge, Ga

      • 2003 SANTE 210

      #3
      Dang it doesn't looked tripped then. Are there fuses somewhere I can check?

      Comment

      • gdhall
        • May 2011
        • 151

        • Bainbridge, Ga

        • 2003 SANTE 210

        #4
        There has to be a fuse somewhere that I'm missing. The only thing not working are the two latch unlocks and an outlet

        Comment

        • pSchwade
          • May 2012
          • 130

          • Reno

          • 07' 220 SANTE

          #5
          On my boat (220) there’s the breaker panel at the drivers kick plate, the battery selector switch has a couple breakers, and there are fuses mounted to the engine. I don’t think there are any accessory type fuses in the engine compartment, it’s mostly engine stuff. There might be an accessory breaker with the perko switch (port rear locker), but I would assume any line would feed the entire breaker panel - so nothing would work. The 12v plug on my boat does have a breaker at the kick panel on my boat.

          The breaker might have died… and I think the whole unit is a sealed assembly, so I’m not sure how you would go about checking it. I don’t have any sort of powered latches.

          Comment

          Working...