14 results in 0.0271 seconds.
-
PCM ZR6 engine - wanted.
I bought a sv211 that was completely rusted. I took the engine out and can't get anyone to touch it. I called many machine shops all over and no luck.... -
Parts Removed from Ski-Boat Engine
Using the engine for another purpose & selling the parts that will not be needed
Parts were removed from a 2014 PCM 6.2L Supercharged...Last edited by Brittany Joyce; 05-16-2020, 09:56 AM. -
Has anyone else had this issue yet?
I have a G23 with a H6 (6.2L), the tensioner arm is gone, you can see in the photos where it sheered... -
Vinegar Flush how to
Ok guys... first, let's just get this out in the open and on the table, I'm an MBSports owner... awkward silence... but I have mad love for the nautiques... -
V-Drive warning light stays on a bit longer
All, I have a 2005 SAN TE 210 and while loaded for surfing (belly tank full, 750 in the bow, 750 in rear locker) my warning light stays on up until around... -
PCM GT-40 Sherwood Raw Water Pump $175
I have a rebuilt (bearings/impeller/plate) Sherwood Raw Water Pump off my '99 ProAir Nautique GT-40 motor.
My bearings blew out, bought a new one... -
PCM GT40 cooling issue on one side
Hi, I have a 1996 PCM 351 GT40 engine and there seems to be reduced water flow on just the port side of the engine. When running the boat with a hose... -
Rebuilt PCM 351 Windsor/GT40 Heads/Multiport EFI - Can't get full range of power
First time poster...hope I'm doing this right. Thank you for being here. First the question, then some info.
Question: What might be causing...Last edited by wsimoneaux; 06-02-2013, 02:54 PM. -
Know anything about these marine starters?
I ordered this starter last week and it came in today. It said it was a marine starter. Does anyone know anything about these?
http://ww... -
1991 Ski Nautique closed bow
Greetings, bit of a newb here as we are not Nautique experts but we do love our boats and really love this one . . . but it has to go due to pending college... -
96 PCM GT40 bogging under acceleration.
Hey,
My GT40 recently started bogging down when I try to accelerate. If I go easy on the throttle I can get it up to a plane and going... -
2003 Super Air - PCM 330 cranking but not starting
I recently purchased a 2003 Super Air Nautique which has the PCM Excalibur 330 engine.
It had been starting normally until now. Now I can't... -
Engine oil question
PCM manual for my 2008 zr6 390 hp specifies 15W-40 GF-4/SM
I've been to 3 auto part stores, none of them have he GF-4 spec.
... -
Distributor Gear Worn 2004 PCM Excalibur 330
I have a 2004 PCM Excalibur 330 with 181 hours. Just bought the boat and have no clue as to the history, but can tell it was not taken care of.
...
Leave a comment: