Tweet
Hi,
I have a '16 SAN 210 with pro ballast.
Last season, LINC was reading 7/8 full for ballast tanks but water emptying into lake thru over flow. In fall, Dealer said likely need to replace sensors but $$$$. Instead they reset the timers thinking they may solve (also had impellers in ballast replaced). This season, LINC showing ballast at 1/2 or 5/8 full when sitting and first start boat. Put on hoist hit drain and there's no water to drain. Pumps work great...filled/drained, etc for surfing. When floating / swimming manually shut off valves just in case but LINC still read 1/2 or 5/8 full on way in. Again, put on hoist and no water to drain.
Anything I can do manually / within LINC to reset timers? I have a dealer code. Or is truly ballast sensors and will need to replace?
Any help appreciated as prefer not to pull boat out and have down time this summer.
Thanks!
I have a '16 SAN 210 with pro ballast.
Last season, LINC was reading 7/8 full for ballast tanks but water emptying into lake thru over flow. In fall, Dealer said likely need to replace sensors but $$$$. Instead they reset the timers thinking they may solve (also had impellers in ballast replaced). This season, LINC showing ballast at 1/2 or 5/8 full when sitting and first start boat. Put on hoist hit drain and there's no water to drain. Pumps work great...filled/drained, etc for surfing. When floating / swimming manually shut off valves just in case but LINC still read 1/2 or 5/8 full on way in. Again, put on hoist and no water to drain.
Anything I can do manually / within LINC to reset timers? I have a dealer code. Or is truly ballast sensors and will need to replace?
Any help appreciated as prefer not to pull boat out and have down time this summer.
Thanks!
Comment