Dash Gauge

[skihard35]

I have a 2010 SN200 and the right gauge is only partially working. The fuel needle works as it should but the voltage needle and the speedo doesn't work inside the same gauge.
Is there an inline fuse or something that I am missing that could be causing this issue?
Any help or insight is greatly appreciated.

[NautiqueJeff]

On a multi-gauge like that, they are normally wired with one source of power, so if the fuel part is working, there is no issue with the power to the gauge. The speed on that boat is likely coming from a paddlewheel. I would check the paddlewheel itself to see if it is damaged and not able to spin properly. Replacement kits are inexpensive and easy to install. Regarding the voltage, check to see that the purple wire is still attached. I bet it is though if the fuel part is working.

There will not be a fuse on any part of the wiring for that gauge. You do have a fuse box under the dash on an SE boat like yours, but none of those fuses have anything to do with the gauges.

There is always a possibility that the gauge itself has failed. Those gauges are available at the link below. Use discount code PND for 10% off if you order one.

https://nautiqueparts.com/gauge-5-3-...-210-se/?aff=2

You might also check to see if the speedometer calibration knob has been turned WAY down. That would make the speedometer read zero all the time.