ISO 200v Port Ballast Tank

[amaaraba]

I have a crack in my port ballast tank and just checking if anyone has one that want to get rid of. 2012 Nautique 200v TE.

[s_kelley2000]

I very much doubt they are the same size but I pulled the tanks out of my 230. If you want to measure yours, I can throw a tape on mine but I doubt they are a match. If I were you, I would switch to bags. The swap is pretty easy to do, you can fit more ballast if you want and it makes working on the motor so much easier with the tanks out of the way. The only downside is the ballast sensor that reports to the gauge/LCD screen won't work with the bags but somebody on this site figured out a good workaround to fix that. I have yet to go through that project to get the sensors back for my rear bags but it's easy to know when full as water will start coming out of the vent. When draining just listen for the pump to change noise and you know you are empty.

[amaaraba]

Thanks for the offer. I did check and they are not the same size. I think I am going to try and plastic weld the crack. If that doesn't work I will just pull for bags.